DIY Wedding: Gold Glittered Pomander Chair Markers
It was around this time two years ago that I discovered a little DIY secret that would forever change my creative repertoire. I now use it in my wedding designs, home accents, greeting cards, and just about everything else I embark on creatively. That little secret is glitter, gold and beyond, and ever since I realized how it could be added to just about anything to majorly up the pretty factor, I’ve been hooked. There’s no detail safe from my glitter addiction and after checking out today’s post, chances are you may quickly join the shimmer squad. Here’s how to use the golden good stuff to create some seriously sparkly chair markers.
- two wooden floral pomander balls – one small and one medium
- fine gold glitter
- gold ribbon, hot glue and a fine tipped tool
- mod podge and a paint brush for application
- tray lined with a layer of paper towels
The Step by Step
Step 1: pour out a generous amount of fine gold glitter onto your work surface. Make sure to first line your surface with a layer of paper towels. The porous nature of the towels will aid to ease the application of the glitter. Next, using a thin tipped paint brush, begin to apply a thin layer of Mod Podge to the tips of the wooden curls of your pomander ball. Avoid too heavy an application of glue as it’ll result in clumpy glitter. Start out the glitter application to half of the pomander, doing so in sections of approximately 5-6 floral curls at a time.
Step 2: once the glue has been applied, roll the florals into the glitter and shake off access. Make sure you apply the glitter quickly after the glue application to avoid the glue drying up. If a spot has been missed, reapply more glue onto that spot specifically and roll in the glitter. Avoid overlapping already applied glitter with glue as it’ll result in a lumpy and patchy finish.
Step 3: for floral centers that are not flush with the curls, apply glue to the center point and manually dust on the glitter. Continue steps 1-3 until half of the pomander is complete, then set aside to dry before working on the other side.
Step 4: push hot glue in between a couple of the florals. Immediately after, using a small fine tipped tool, push through a piece of gold ribbon that has been fold in half, at the halfway point. Hold for a few seconds to set. Once dry, the pomander is complete. Repeat steps 1-4 for your other pomander.